Name：CR-6 wire winding machine Model：CR-6 Category：Wire torsion testing machine | Torsion testing machine Price：negotiable Place of origin：Jinan

Productoverview:

CR-6 Wire Wrapping test machine is mainly used for detection of uncoated and coated metal material is subjected to combination of firmness and surface defects of wound surface coating shows the deformation.

Two, technical parameters:

The diameter range: 0.5-6mm

Winding speed: 15, 20, 60r/min

Dimensions (mm): length * width * height

700 x 360 x 955

The weight (kg): 300

Three, operation guide:

The CR-6 wire winding testing machine is mainly used to check the diameter is equal to or less than 6mm of uncoated and coated metal wire bearing winding deformation after combined with solid surface defect and surface coating.

1 test preparation

A. according to the test wire, find the corresponding standard.

Check test machine power device and move is a good beginning.

　　------------------------------------------------------------------------------------------------------------------

Extended reading:

The working principle of CR-6 wire winding machine

CR-6 Wire Wrapping test machine is in accordance with the relevant provisions of the standard sample spot diameter of the mandrel tightly wound spiral ring number of the provisions, may also include special ring winding, solution procedure and even wound.

Test equipment CR-6 wire winding test machine should meet the wire around the mandrel winding, and the adjacent coils of closely spaced spiral coil. As a test material, as long as in accordance with the provisions of the mandrel diameter and having sufficient hardness, can also be used as mandrel.

CR-6 winding test machine note

1, the test should generally be performed at 10 DEG -35 DEG at room temperature

2, in the absence of any sample in the case of torsion, no more than one ring per second by the prescribed speed close direction along the spiral wound on the mandrel. When necessary, can slow down the winding speed, to prevent the increase of temperature affects the test results.

3, to ensure that the compact winding, winding can be applied no more than 5% of the value of tension wire nominal tensile strength corresponding force at the free end of sample. If the solution circle or circle solution after winding, the winding speed and solution circle should be slow, to prevent the increase of temperature affects the test results, when the sample end ring solution should be retained for at least one winding.

4, CR-6 wire winding machine should be in accordance with the provisions of relevant results to determine the implementation of the standard test winding. If there is no specific requirements, can check the sample surface without amplification tools, such as no cracks were found in the specimen will be acceptable. The diameter or thickness of less than 0.5mm of the wire should be checked in the magnified about 10 times.